Deck patch material - 0.5 m^2

Quick Overview

140 g/metre2, self adhesive Dacron, also suitable for sail reinforcement, 1370 x 375 mm, 0.5m2. Red and silver are now back in stock.


OTHER SIZES to suit your cutter are possible - contact the SAILSetc office for prices.


 

Product code. DP-MAT

Availability: In stock

£0.00

* Required Fields

£0.00

Deck patch material - 0.5 m^2

More Views

Details

140 g/metre2, self adhesive Dacron, also suitable for sail reinforcement, 1370 x 375 mm, 0.5m2. Please select colour.

Cut deck patches from this self adhesive Dacron which does not leak or degrade with exposure to UV light. Whereas plastic films become brittle with exposure to UV and the cold, this material will minimise the risk of sinking if used properly.

Other uses

Use this material for the larger areas of sail corner reinforcement as it is soft and spreads the load from the eyelet well to the body of the sail. To build up thickness quickly at the area near the eyelet/headboard you may prefer to use the thicker patch material underneath, ref. SP-05.

Also useful for emergency hull repairs and for adding slides to the luff of a mainsail as shown in the thumbnail sketch.

Applying the patches

To apply the deck patches with the minimum of effort and error keep a small jar of water to which some liquid hand soap has been added. Use just enough soap to allow the water to be spread all around the deck surface where the patch will be fitted without the water pulling back to leave dry areas. Peel off the backing material and place the patch over the aperture. The soapy water will allow you to move the patch around until properly placed and taut. In warm, dry, weather it may take 30-45 minutes to dry. Allow double that time if cold.

Vent the boat

Always remove the patch over the rc equipment after sailing to allow the inside of the boat and the rc gear to dry properly. Save the patch onto the backing sheet for re-use if it is clean. Wash in fresh water if contaminated with salt water. Replace the patch with new if the adhesion has been lost.

Removal of patches

After removal of deck patches or sail marks there will usually be patches of adhesive remaining on the hull or sail surface. From the hull these are best removed using a small scrap of deck patch material repeatedly applied and removed. This can remove the majority of the adhesive. Remove the adhesive from sails and the remainder from the hull using solvent. Cellulose thinners is most effective in our experience. Acetone is less effective but does work.

© 2019 SAILSetc Ltd