Servo/tiller arm connector - tube and/or ends

Servo/tiller arm connector - connector tube with or without the threaded ends. The length of tube required is 80 mm less than the distance between the axis of the rudder stock and the servo output shaft. There will be + or - 15 mm of travel each side of that.

Use this page to choose the parts you need:

Ball joint connectors - pair. Pair of threaded end fittings, one left hand thread, one right hand thread designed to fit the alloy tube.

And/or

The connector tube; choose from 200, 300, 400 and 500 mm long. This is an alloy tube only - it is cut from an Easton 1616 arrow shaft - 6.3 mm outside diameter x 05.5 mm internal diameter.

The ball joint connectors comprise injection moulded inserts that are a push fit into the connector tube - one end has right hand M3 studding - the other end has left hand M3 studding. They can be used with the servo tiller connector tube to create a compression strut so that rotating the completed unit adjusts the length between the connecting holes thus allowing precise setting of this connector.

Supplied with a M2 screws and nuts for attachment.

066-ENDS-TUBE