Dyneema - 100 kg breaking strain

Quick Overview

Dyneema - 100 kg. For running rigging, white, yellow, orange or blue, braided. 0.8 mm Ø, 20 or 100 metres.


Product code. D100

Availability: In stock

£0.00

* Required Fields

£0.00

Dyneema - 100 kg breaking strain

More Views

Details

Dyneema - 100 kg. For running rigging, white, yellow, orange or blue, braided. 0.8 mm Ø, 20 or 100 metres.

Use with 057B bowsies. Dyneema does not melt so you cannot seal the end of the line or a knot by using a flame or soldering iron. Instead cut Dyneema with very sharp scissors to ensure a clean cut. Alternatively use a thin cyanoacrylate glue to stiffen the line where it is to be cut and use a sharp cutting knife (we use snap off blades to ensure a sharp edge) on a cutting mat to make a clean cut at an acute angle to the line. This provides a neat needle like point that can be threaded through bowsies and other fittings.

Use a figure of eight, stopper or stevedore knot with bowsies. Use a loop with an overhand knot or a bowline with hooks. Seal knots with a spot of cyanoacrylate glue.

Does SAILSetc Dyneema line fray?

Fraying of any line, however strong it is, will happen when it runs over a sharp edge on a fairlead or boom band. If your lines persistently suffer this sort of damage, replacing them with another line will not help. The problem is with the fitting, not the line. All SAILSetc fittings designed to be used as fairleads or boom bands are de-burred and tumbled to remove internal and external sharp edges - use them to replace your faulty fittings to eliminate frayed lines.

Doubtful about suitability of this line? See downloadable document: Rigging Guide

Making terminations in wires and lines: here

Information about bowsie and Dyneema yield loads: here.

Dyneema, sometimes misspelled Dynema, Dinema.

Previously D110.

© 2019 SAILSetc Ltd